Glittered Vintage Thanksgiving Sign

Posted in Art Glitter Design Team, Main, Sharing the Handmade Love at 9:30 am by carrie

Today I’ll be making a hanging Thanksgiving sign out of a vintage postcard that I found at an antique shop.

I scanned that postcard in, blew it up and printed it. I used a piece of chip board, for the base of the sign.

I used pinking shears to cut out the enlarged vintage postcard copy and the “give thanks” page (see below) and outlined the image using Art Glitter Vintage Glass Golden Glow #612 Glitter and Art Glitter Designer Dries Clear glue to put that glitter on.

I then got an 8 1/2″ x 11″ piece of white card stock and used one of my Tombow Dual Brush Pens #098 in Avacado green to write “Give Thanks” over and over and over again to use as a background for my sign…

Here’s the sign as I added more colors of glitter. Art Glitter Vintage Glass Red Damask #608 Glitter, Ultrafine Opaque Cat Eyes yellow glitter #361, Ultrafine Transparent Clear Glitter #89 Martini, and Ultrafine Opaque Calvado Green #109.

While the glitter dried, I started to put together my antique crepe paper border. I decided to use my new Tombow Stamp Tape Runner to put this together…

I have to say… I was very pleasantly surprised! Normally when I put on a crepe paper edge ruffle like this on anything, I use hot glue or wet glue and I make a MESS. This tape was easy to put down in straight line…

And as I folded the crepe paper, I could turn the Stamp runner vertically and push down the handle to give me just a small square of the tape. It was awesome!

The great part about the tape is that it’s not permanent until you press it down hard and leave it for a while. If I put down the crepe paper, but didn’t like it, I had time to move it and it didn’t tear the crepe paper.

So I was able to finish the frame in no time… it’s the fastest crepe paper border I’ve ever done!

I then quickly added my orange crepe paper. Which is just white crepe paper painted with orange watercolor to give it a muddled-faded look.

I then put down my “Give Thanks” page, again using the Stamp Runner.

And then the Thanksgiving postcard…

I then put down some Tombow Mono Multi Liquid glue, which is acid free and has two sides with two different applicators. One with a flat nose, for putting it onto paper, and one with a fine tip for smaller projects. This glue is super sticky and stretches, too. I put my ribbon into a daub of glue on one side, then the other.

Added some glittered flowers…

And a bow on top… and it’s finished!